SIATA SFE VOLUMETRIC TIMER CONTROL UNIT WITH TURBINE CABLE (PENTAIR WATER)

Description

SIATA SFE VOLUMETRIC TIMER CONTROL UNIT WITH TURBINE CABLE (PENTAIR WATER)
Complete with turbine cable for volume reading.
*The new generation SFE control unit replaces all the old SIATA control units, produced by Digic Srl: XP, XP Mode, Aquatimer, Aquaionic controllers, you can fully replace it as it is totally compatible with those listed above. (SEE ADDITIONAL PHOTOS)
- It can be used to replace ECUs with the following codes: XP0-01/05, XPMOL-01/05
- Spare part compatible with some softener models: Lamborghini, Aquasoft, MetaLife, Gel, Decalux, Idro Service, Manta, Corallo, IDROSTAR, etc..
- Compatible and suitable for all SIATA Pentair Water valves: V132T
+ Call for clarification.

The SFE controller is a device that allows the management of softening or filtration systems and is based on two electronic boards; both suitable for chronometric or volumetric regenerations.
The SFE - Pentair Water control unit allows you to manage the V132T - V230T valves of softeners, clarifier filters, iron removers, dechlorinators, activated carbon filters, sand filters, etc.
Through the use of the control unit it is in fact possible to program the washing phases, the washing frequency, the regeneration time, alarms, etc.

The SFE Timer controller allows you to manage different inputs and outputs through an external terminal block (*attached photo*):
- Siata meter sensor 2223-50
- Reed sensor meter
- Chlorine cell cable 2226-C45
- Inhibit
- Remote start
- Secondary microswitch (could give normally closed or normally open consents to secondary accessories such as solenoid valves, etc..)

Quality:
• Simple and intuitive programming
• Large backlit LCD display during programming
• Indication of the day of the week and time of day expressed in hours and minutes
• Time of day alternates with volume remaining while in service (if equipped with volume readout cable)
• Visualization of the regeneration phases and residual cycle time
• Quick and easy configuration of regeneration capacity, time and day
• Advanced programming options, including the ability to program up to 4 regeneration cycles with independent time adjustment
• Manual, delayed or immediate, chronometric or weekly chronometric regeneration.
• High regeneration frequency (every 1/2/3/4/6/8 or 12 hours)
• The set programming remains in the EEPROM memory and will not be lost in the event of a power cut
• Standard interchangeable lithium battery (#CR2032)
• Statistical mode indicators
• Operation of the chlorine cell or the optional external solenoid valve
• Electric power: 230 V / 50 or 60 Hz transformer 12 VAC (6 VAC if chlorine cell)
• Temperature: from 2-43°C
• Complete with turbine cable for reading the volume of water consumed


WARNINGS
Read the user and maintenance manual carefully before using the device.
Do not power the equipment with voltages other than those specified in the manual included in the product packaging.

## SEE THE PHOTOS TO SEE ALL THE OLD CARD MODELS IT REPLACES ##