OSMOBASIC DIRECT 600 - REVERSE OSMOSIS 600 GPD DIRECT PRODUCTION

OSMOBASIC Direct Production Reverse Osmosis 600 GPD (gallons)
5-stage reverse osmosis water purifier.

Produces up to 2,400 liters per day of low-mineral water.
It has no water buildup and produces instantaneously and directly; you can fill a 1-liter bottle in less than 40 seconds.
The system is assembled on a supporting bracket that allows it to be mounted on a wall or placed on a base.

The OSMOBASIC 600 RO system directly produces up to approximately 100 liters/hour of low-mineral water.

The system is equipped with a needle valve for regulating the fixed residue of the water being produced. The valve on the system can be used to adjust the electrical conductivity (salinity) of the water supplied by the system.

RO Osmobasic consists of three 10" cartridge prefilters:
- Stage 1: Carbon Block Filter - CBC 10" - 10 microns
- Stage 2: Granular Activated Carbon Cartridge Filter - GAC 10"
- Stage 3: 1 micron Sediment Filter - MB 10" - 1mcr.

It then switches between two reverse osmosis modules.
- Stage 4: Two 300GPD reverse osmosis membranes
- Stage 5: Flavor-refining filter - 10" inline T33

The system is fully automatic and has no water tank.
The maximum pressure switch automatically shuts down the system at the end of dispensing, while the minimum pressure switch prevents the system from turning on if there is no incoming water, thus protecting the pump.

The system comes with an installation kit:
- Assembly instructions
- Connection piping
- Water inlet with diverter
- Bracket socket for drain connection
- Purified water dispensing tap
- Filter tightening wrench
- Membrane container vessel opening wrench
(everything needed for installation)

Overall dimensions: 400*220*480mm

** DOMESTIC APPLIANCE FOR THE TREATMENT OF DRINKING WATER INTENDED FOR CONSUMPTION HUMAN COMPLIANT WITH DECREE LAW N.443 OF THE MINISTRY OF HEALTH OF 21/12/90.